MakerPlace Workshop: Introduction to 3D Printing
Learn the basics of 3D design and printing to make a personalised keyring. For ages 16+
As 3D printing takes a long time, your print will need to be collected at a later point. We will contact you to let you know that your print is ready for collection, or we are able to send the print to any Gateshead Council Library for collection. Please note that a minimum booking number of 3 people is required for this workshop to go ahead. If less than 3 tickets are sold, we will contact you and refund your ticket. Participants must have basic keyboard and mouse skills. Late Arrivals: It will not be possible to join a workshop if you arrive more than 15 minutes late. By this time in a workshop, technical knowledge will have been covered and it won't be possible to go back over this information. Mobile Phones: We ask that mobile phones are not used during a workshop. Food and Drink: Only covered beverages are allowed in the MakerPlace, we ask that you keep drinks away from the equipment and computers. No food is to be consumed in the MakerPlace. Refunds: Please see our Gateshead Libraries Event Terms and Conditions for our refund and cancellation policy.